The vibration resistance of young and early-age concrete
Anders Ansell, Postdoctoral fellow, Department of Civil and Architectural Engineering, Royal Institute of Technology (KTH), Stockholm, Sweden Johan Silfwerbrand, Director, Swedish Cement and Concrete Research Institute (CBI), Stockholm, Sweden
During early age, concrete is vulnerable to disturbance from vibrations of large magnitudes. Today, conservative vibration limits are used as standards, and guidelines provide little information. The literature cited in this study contains experiences and results from the construction and civil engineering field, in-situ testing, laboratory testing and computer modelling. On the basis of the reviewed literature, recommended maximum vibration levels for young and early-age concrete are given.
Investigation of temperature and strain distribution in reinforced-concrete wall of a rapeseed storage silo
K. Diamoutene, Wroclaw University of Technology, Poland M. Kaminski, Wroclaw University of Technology, Poland
The results of experimental research carried out on reinforced-concrete storage silos and of a numerical analysis of the temperature distribution in the silo wall are presented. Temperature fields in the structure were determined and the finite element method was applied to analyse the forces and moments generated by the thermal fields.
Theoretical model for the determination of plastic rotation capacity in reinforced concrete beams
R. N. F. do Carmo, Department of Civil Engineering, ISEC-Polytechnic Institute of Coimbra Portugal S. M. R. Lopes, Department of Civil Engineering, FCTUC-Polo II-University of Coimbra Portugal L. F A. Bernardo, Department of Civil Engineering, University of Beira Interior Portugal
Evaluating the ducility of reinforced concrete beams is essential in order to avoid a fragile collapse of the structure by ensuring an adequate deformation at ultimate load. This paper presents a theoretical model for the calculation of plastic rotation. Results obtained are compared with those obtained from an experimental programme in which a set of beams were tested to failure. From the comparison, a good agreement between theoretical and experimental results was achieved. The proposed theoretical model considers the influence of certain factors: steel properties, concrete strength, section depth, and the tension stiffening effect. Concrete strength, particularly, is an interesting parameter since for high-strength concrete, the ultimate concrete strain, εcu, decreases as the concrete strength increases.
This paper provides a brief overview of Session 8 'Durability of Concrete Structures' of the fib 2002 congress on Concrete Structures in the 21st Century, which was held in Osaka on 13-19 October 2002. The keynote speaker of the session, Dr Odd E. Gjørv, Professor and Head of the Department of Building Materials at the Norwegian University of Science and Technology at Trondheim, has conducted concrete research for more than 40 years. His research has focused on a broad range of topics related to the durability of reinforced and prestressed concrete structures in severe environments. His paper addressed durability and service-life issues of concrete structures. In addition to the keynote address, more than 50 papers were considered for this session, covering topics in the following areas: general issues related to concrete serviceability and durability, corrosion of reinforcement, and grouting of post-tensioned systems, as well as several case studies. The highlights of some of the papers are described here.
Structural behaviour of steel fibre reinforced concrete
I. Kovacs, College Faculty of Technology, Department of Civil Engineering, University of Debrecen, Hungary G. L. Balazs, Budapest University of Technology and Economics, Department of Construction Materials and Engineering Geology, Hungary
Results of an experimental study on 21 fibre reinforced concrete beams indicate that steel fibres do not only increase shear capacity but also provide substantial post-peak resistance and ductility in conventionally reinforced beams as well as in prestressed pretensioned concrete beams. The tests were carried out on 2m long beam specimens reinforced with longitudinal bars and fibres. Test variables were amount and type of fibres, amount of stirrups and type of longitudinal reinforcement (prestressed or non-prestressed).
Structural behaviour of steel fibre reinforced concrete
I. Kovacs, College Faculty of Technology, Department of Civil Engineering, University of Debrecen, Hungary G. L. Balazs, Budapest University of Technology and Economics, Department of Construction Materials and Engineering Geology, Hungary
Results of an experimental study on 21 fibre reinforced concrete beams indicate that steel fibres do not only increase shear capacity but also provide substantial post-peak resistance and ductility in conventionally reinforced beams as well as in prestressed pretensioned concrete beams. The tests were carried out on 2m long beam specimens reinforced with longitudinal bars and fibres. Test variables were amount and type of fibres, amount of stirrups and type of longitudinal reinforcement (prestressed or non-prestressed).
